Original 3D Printing Setup for Lunar Prototypes
I wanted to write about where I'm at from a 3D printing perspective when I'm starting this venture so I can look back upon it fondly one day and see if anything has changed. In this post I'm going to detail my current 3D printing setup, slicing software I use, and where I hope to go. As I wrote this post, I was reminded of every single recipe article on the planet that has like six hours of narrative before you finally scroll to the recipe, so in an effort to break that trend, I'm going to BLUF (Bottom Line Up Front) this. BLUF Recommendations This is my current recommendation for mods. Note, this will absolutely change as I learn and grow. But it's worked for me to this point. Current Printer: Ender 3v2 Current Mods: Ferrule Crimped Power Supply Leads PEI Print Bed Silicone Bed Springs Red Bed Leveling Wheels Briss Printer Duct Voron M4 Extruder Klipper running on a Raspberry Pi CR Touch Tested Mods: Cable Chains Dual Gear Extruder Current Slicing Software: Su